News

Home > News

Glass Shower Enclosure installation tips

Nov. 25, 2019
Share

Glass Shower Enclosure installation:

Install the bottom basin: Combine the bottom part and adjust the level of the bottom basin to ensure that there is no water in the basin or the bottom of the basin. The hose can be telescoped with distance, and the bottom of the basin is firmly connected to the floor drain.

Test and protection: After installation, a test water test is needed to ensure unimpeded water flow. Fourth, find a position, punch: use a pencil, level to determine the drilling position of the wall aluminum, punch with a hammer drill.

Install the aluminum: Knock on the rubber in the hole and lock the aluminum bar to the wall with a screw.

Fixing the glass: Lock the glass to the hole in the bottom basin and fix it with screws.

Install the top tube: Find the corresponding position drill hole above the fixed glass, install the (straight/oblique) fixing seat and connect the top tube. Secure it to the top of the glass with a bent sleeve.

Installation rack: Align the position of the device rack, tighten the plate nut, and fix the laminate glass to maintain vertical and horizontal. Be careful to waterproof under the fixed glass of aluminum.

Install the movable door: Install the hardware of the movable door and install the hinge on the reserved hole of the fixed door. After installation, adjust the position of the shaft of the lotus leaf until the door feels the best.

Waterproof: Install suction strips or water retaining strips on the side or below the glass as required. Use aluminum mesh to seal the seam between the aluminum and the wall, glass and bottom basin.

Debugging and fastening: Check whether all parts are comfortable and smooth, and find problems in time. After adjusting, tighten the corresponding screws to make the whole shower room firmer.

Finishing work: The decorative aluminum strip is snapped into the wall-mounted aluminum material to ensure that the appearance is neat and generous. Finally, wipe the entire shower room with a rag.

As a Glass Shower Enclosure Supplier, let’s talk about the buying skills in the shower room.

Frameless Shower Enclosure

Frameless Shower Enclosure

1. Look at the stability of the shower rod

Analysis: The pull rod of the shower room is an important support for the stability of the Frameless Shower Enclosure. The hardness and strength of the tie rod are an important guarantee for the impact resistance of the shower room. It is not recommended to use a flexible lever, which is weak.

2. Look at the shower room water tightness

Analysis: The main observation area of the water tightness of the shower room is

 Shower room and wall connection

 Door and door joints

 Hinges water tightness - hinges because of activities, water tightness is often bad

 Shower room and stone base, bottom basin connection

 Check the tightness of the strip and strip

3. See if the product design is humanized

Brief analysis: quality frame, sealed magnetic strip, buffer device, easy to clean, detail treatment (whether the attached cover is complete, whether the hand feels smooth).

4. Distinguish acrylic material

The plates used in the shower room are mainly acrylic sheets. It is understood that the glass yarn used in some composite acrylic sheets contains formaldehyde, which is one of the sources of toilet pollution. The way to distinguish the acrylic material is to look inside the shower room. If the backside of the acrylic board is different from the front side, it is rough and it belongs to the composite acrylic board. For example, some acrylic sheets will change color when used for too long, and some will have small cracks. This is also the main reason why some brands have expensive shower rooms, and some are cheap.